Mitel Panther II 820 System Manual page 216

TriIIium Standard Practice
Resetting Keys to their Default Values (Code 000)
3.10 Keys that have been programmed can be reset to their preprogrammed (default)
setting by using the following procedure (e.g., if you have programmed the Line 1 key
on a Set as a Night Pickup key, then wish to convert it to a Line 1 key again). Note
that you can reprogram a key without having to reset it to its default setting fmt.
To reset keys to the default values:
l
Press the PROGRAM Key (or dial * #), then dial 4.
l
Press the key you vish to reset.
l
Dial 0 0 0.
l
Press * to exit Programming Mode.
l
Repeat the procedure for each additional key you wish to reset.
The keys default to the line keys and DSS keys that are shown on the set's designation
card in printed type.
TABLE 3-1
PROGRAMMABLE KEYS
With the Panther iI System, keys on a Set can be programmed as line keys, line pool
keys, DSS keys, or feature keys. To convert a key -
1.
2.
3.
4.
5.
At the Set, press the PROGRAM key (or dial * #).
Dial the digit 4.
/
Press the key that you wish to change.
Dial the appropriate code below -
001 - 020
= a specific line from 01 to 20.
(LINE KEYS)
051 = Line Pool 1
052 = Line Pool 2
053 = Line Pool 3
(LINE P@@L KEYS)
054 = Line Pool 4
050 = Saved Number Redial
057 = call Pickup - Local
058 = Call Pickup - Remote
(FEATURE KEYS)
059 = Night Pickup
060 = Do Not Disturb
061 = Program
062 = Unused Key
(UNUSED KEYS)
910 - 973
= a specific station from 10 to 73,
(DSS KEYS)
Press * to exit programming.
. .
/
Now the key selected in Step 3, has been changed to the new function selected
in Step 4.
~~
Programming
Page 56