Mitel Panther II 820 System Manual page 256

Panther II 820/1032/2064-200
Step 2. Plug the KSU power cord into the grounded 110 Vat electrical outlet.
The status lamp on the KSU flashes.
Step 3. Set the BATTERY switch (Switch 4) to the ON position.
(Leave the BATTERY switch in the ON position for memory retention.)
Step 4.
Step 5.
Step 6.
Step 7.
Set the PROGRAM 2 switch to the ON position.
Press the RESET button.
Set the PROGRAM 2 switch to the OFF position.
Press the RESET button. The system is now set with the factory
preprogrammed conditions (see the programming section for details).
Step 8. Before you proceed to the programming section of this manual, connect
a Panther II Display Set to station 10. It is essential that you use a
Panther II Display Set at station 10 when you program the system.
Set Check
7.03 To check the operation of the Panther telephone sets, plug each Panther
telephone set into its modular station jack and perform the following test. Refer to
Panther II 820/1032/2064-320, Maintenance and Troubleshooting,
if a Set does not
respond as stated.
Step 1. Press the Intercom or # key-
a continuous tone is heard through the
speaker and the Intercom indicator lamp lights.
This
step
indicates that
an intercom path has been accessed.
Note: When testing a Set with a corresponding DSS/BLF Console, the station lamp on
the set and the DSS/BLF will be lit.
Step 2.(a)
tb)
Lift the handset and press Line key 2 - the Internal indicator lamp turns
OFF, dial tone is heard through the earpiece and the Line indicator lamp
for line 2 lights.
OR
On the Panther II Set (Basic Set), dial 302 while on-hook and listen for
dial tone.
Step 3.(a)
(b)
Replace the Handset -
all indicator lamps turn OFF.
OR
On the Panther II Set (Basic Set), press the SPEAKER key.
Step 4. Repeat Step 1 through Step 3 for each Panther telephone set in the
system.
Installation and Commissioning
Page 37