Table of Contents
Advertisement
Trillium Standard Practice
Step 6.
Program the Day/Night Mode selection for incoming DISA line 2 (only if you
programmed
an incoming DISA line 2 in Step 3).
a. Dial access code 0381.
b. Dial data code
0 for Day off/Night off (default setting),
1 for Day on/Night off,
2 for Day off/Night on, or
3 for Day on/Night on,
c.
Dial # to store your selection.
Step 7.
Enter the desired release time. Note that the length of time selected will also
determine the release time for ECF. To program the DIWECF
release time:
a.
Dial access code 027.
b.
Dial data code
0 for 30 seconds,
1 for 1 minute (default setting),
2 for 2 minutes,
3 for 3 minutes,
4 for 5 minutes, or
5 for 10 minutes
C.
Dial # to store the release time.
Step 8.
Press * to exit programming.
Operation
You can only use the DISA feature from a tone dial (DTMF) telephone.
To make an internal call to a station:
Call into the office on an incoming CO. line that is programmed
for DISA
You will hear two bursts of ringing and then the system automatically provides internal
dial tone.
Dial #XXXX# (where XXXX=the 4-digit DISA access code)
If you enter the code correctly you' ll hear internal dial to&e; if
you
enter it incorrectly,
you will hear an error tone. If you hear error tone, you must hang up and call again.
Dial # then dial the number (10-73) of the desired station
You will hear internal ringing tone. If your call isn' t answered you may dial *, dial #
then dial the number of another station, or dial * and hang up. If your call is an-
swered, when
you finish
your conversation, simply
Hang up to end the call
To access a C.O. line and place an outgoing call:
l
Call into the offke on an incoming C.O. line that is programmed
for DISA
You will hear two bursts of ringing and then the system automatically provides internal
dial tone.
l
Dial #XXXX# (where XXXX=the 4-digit DISA access code)
If you enter the code correctly you' ll hear internal dial tone; if
you
enter it incorrectly,
you will hear an error tone. If you hear error tone, you must hang up and call again.
l
Dial 3, then dial the number (01-20) of the desired line
You will hear internal dial tone. If you hear a busy signal dial *, dial 3 then dial the
number of another line. When you have internal dial tone,
Feature Module II & Options Interface
Hardware
Page 20
Advertisement
Chapters
Table of Contents
