Mitel Panther II 820 System Manual page 129

Trillium Standard Practice
If Intercom On Hold (Access Code - 040) is programmed for the system,
you can establish a mixed conference call by adding an external call to your
intercom call on hold.
Conditions
None
Programming Required
None
\
/'
DIAL SIGNAL CONVERSION
Description
While an external call is being dialed, if the user presses the * key, the
Panther II system will switch from pulse dialing to tone dialing for the
remaining digits in the call. This allows the user to have access to tone
dialing. The Set reverts to pulse dialing when the call is completed (when
the user hangs up).
Conditions
l
The Panther II System must be connected to rotary lines, and be
programmed for Pulse operation in order for this feature to operate.
Programming Required
l
Access Code 060 - Pulse or Tone Dialing
DO NOT DISTURB
Description
The Do Not Disturb feature prevents all external calls, internal calls and
paging announcements from ringing at the Set. Any user trying to page the
Set hears busy tone. The Intercom indicator flashes while Do Not Disturb is
on. If a Panther II Display Set user calls or pages a Set with Do Not
Disturb activated, the user will see the DND Message on their LCD.
Programmable Feature Keys allow a specific key to be programmed as a Do
Not Disturb key (See Section 5, PROGRAMMABLE FEATURE KEYS for
more details).
Conditions
l
A user with Do Not Disturb activated at their Set can only be interrupted
by a user with DO NOT DISTURB OVERRIDE capability. See DO NOT
DISTURB OVERRIDE, below for more details.
Programming Required
None
,;,
Features and Services
Page 36