Table of Contents
Advertisement
Trillium Standard Practice
FEATURES
3.03
This section provides descriptions
and programming
instructions for the features
made available by the Options Interface Hardware Unit.
Amplified Lines
Normally, during an external conference there is a slight reduction in the voice signals
over the C.O. lines. To remedy this inconvenience,
the Options Interface Hardware Unit
has a built-in amplifier that compensates
for reductions in the voice signals on external
conference calls.
External conference calls can be set up with either amplified lines or non-amplified
lines.
If you initiate a external conference call and you hear two bursts of tone, the lines you are
using are amplified. If you hear a single burst of tone, then the external conference has
been established with non-amplified
lines.
The Options Interface Hardware Unit can amplify any four C.O. lines at one time. Trunk
to Trunk Conference,
External Call Forwarding and external calls using Direct Inward
System Access each require two amplified lines. If you set up an external conference
when all the amplified lines are busy, you will hear a single tone. The single tone indi-
cates that you aren' t using amplified lines and that you can' t set up a Trunk to Trunk
Conference.
If you try to use External Call Forwarding or Direct System Inward Access
when all the amplified lines are busy, you will hear continuous ringing.
Trunk to Trunk Conference
The Options Interface Hardware Unit allows you to set up trunk to trunk conferences
using amplified lines. When you' re on an external conference call, you can hang up
while allowing the two external parties to remain connected for a preprogrammed
length
of time. Before the preprogrammed
time period expires, the outside parties will hear an
1 l-second tone. Either party can restart the preprogrammed
time period by dialing *
during the tone. If neither person dials *, they will be disconnected
at the end of the ll-
second tone.
Programming
The length of time that the external parties remain connected after you hang up is pro-
grammable.
The possible selections are: 0 minutes, 3 minutes (default setting), 5 min-
utes and 10 minutes.
To change the default setting:
Step 1.
At Station 10, dial *# (or press the Program key).
Step 2.
Dial 015. The Intercom indicator lamp turns on and the display confms
that
you' re in programming
mode.
Step 3.
Dial 024 (access code for Trunk to Trunk Conference).
The Intercom indicator
lamp flashes quickly.
Feature Module II & Options Interface
Hardware
Page 16
Advertisement
Chapters
Table of Contents
