Mitel Panther II 820 System Manual page 196

Trillium Standard Practice
TABLE 2-11(a) STATION SECURITY
___________________________~___~~~______~~~~~~~~~~~~~~~~~~~~~~~~~~~~~_____________~~~~__~~~~~~___~_____
This feature prevents unauthorized users from accessing an outside line at a station.
Before an outside line can be obtained, users must dial a security code.
Programming instructions provided on this page must be completed from the Master
Station (preprogrammed as Station 10). Station Security is programmed in two stages.
During the first stage, you enter up to six 4-digit security codes into the system's
memory. During the second stage, you assign each station to one of four Station
Security levels: High Level, Day Level, Night Level or Low Level. Refer to STATION
SECURITY in this Section for more details. The security level determines when a user
must enter one of the 4-digit security codes that you programmed into the system.
NOTE: It is recommended that Toll Securiry codes be changed on a frequent basis, and
that security codes be given out ONLY to hose individuals who will have override
privileges.
PROCEDURE 1 - TO SET UP STATION SECURITY CODES
1.
At Station 19, press the PROGRAM key (or dial * #) to enter Programming
Mode.
2.
Dial the digits 0 5.
3.
Dial one of the six Station Security codes that you wish to change (1 to 6):
l
1 -
Security Code 1.
l
4 -
Security Code
4.
l
2 -
Security Code
2.
l
5 -
Security Code 5
.
l
3 -
Security Code
3.
l
6 -
Security Code
6..
4.
For the Code chosen in Step 3, now store any combination of four digits (0000
to 9999) which will allow a user to override Station Security (e.g., 2345).
Preprogrammed values are 9999 for all six Security numbers.
Using a pencil,
write the stored number on the corresponding line in Step 3.
5. Press the * key to exit programming. The procedure can be repeated at any
time, to overwrite/change a Station Security Code.
Programming
Page 36