Mitel Panther II 820 System Manual page 179

Panther II 820/1032/2064-205
TABLE 2-6 LOUD BELL/RELAY CONTROL PARAMETERS
Feature Access Condition Data
Description Code (Values) Code
____________________-------------------------------------------------------------
Loud Bell/ 018 Loud Bell* 0
Relay Control. Relay Control
1
______^_____________~~~~_~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Loud Bell Ringing,/
063Xx
Rings selected line during
Ringing Over Raging By Line Day Mode* 0
(DAY MODE)
____________________~~~~~~---~-~~~~~-----~~~~--~
Does NOT ring selected line
during Day Mode 1
____________________~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Loud Bell Ringing/ 064xx Rings selected line during
Ringing Over Paging By Line
Night Mode* 0
(NIGHT MODE)
___~________________~~~~~~~-~~~~~~~~---~~~~~~-
Does NOT ring selected line
during Night Mode 1
____________________~~~~~~-~~~~~~~~~~~~~~~~~~~~~~~_~~~~~~~~~~~~~~~~~~~_~~~~~~~~~~
Auto/Manual 019 Automatic Return to OFF* 0
Return to OFF
Manual Return to OFF 1
____________________~~~~~~------~~~~~~~~~~~~~~~~~~~~~-~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
Auto Return to OFF 052
20 ms
Timing
40 ms Fz
60 ms
80 ms :;
1OOms
200 ms :4
300 ms
400 ms
0";
500 ms
08
600 ms
09
700 ms
10
800 ms
900 ms ::
1 second*
2 seconds ::
3 seconds
15
____________________~~~~~~---~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~_~~~~~____~~_~~_____~
Notes:
l
denotes preprogrammed value.
xx = a line number from 01 to 08 on the Panther II 820 system, or 01 to 10 on the Panther
II 1032 system, or 01
to
20 on the Panther II 2Oq4 system. To program these access codes,
you will need to enter each C.O. line number that needs to be changed from the
preprogrammed value (one at a time).
Programming
Page 19