Mitel Panther II 820 System Manual page 61

Trillium Standard Practice
3. OPTIONS INTERFACE HARDWARE UNIT
GENERAL
3.01 When used with Feature Module II software, the Options Interface Hardware
Unit enhances the operation of Panther II systems by providing the following
new features:
l
Amplified Lines,
l
Trunk to Trunk Conference,
l
External Call Forward, and
l
Direct Inward System Access.
Note that you can only use the Options Interface Hardware Unit if your system has
Feature Module II software. In addition the Options Interface Hardware Unit uses the
following stations on the Key System Unit (KSU):
l
Stations 28 to 29 on the Panther II 820 System
l
Stations 28 to 33 on the Panther II 1032 System
l
Stations 28 to 33 on the Panther II 2064 System
Therefore, sets connected to these stations will be inoperative.
INSTALLATION
3.02 The Options Interface Hardware Unit connects to a port on Panther 820 or 1032
Key Service Units. Follow the procedure listed below to install the Options Interface
Hardware Unit.
Step 1.
Step 2.
Step 3.
Step 4.
Step 5.
Step 6.
Ensure the Battery Switch for the KSU memory is in the ON position. The
Battery Switch (dipswitch #4) is located on the right-hand side panel of the
KSU.
Unplug the KSU power cord. Telephone service ,will be disconnected.
Remove the woodscrew from the bottom right-hand flange of the KSU.
Position the Options Interface Hardware Unit connection plate over the screw
hole in the bottom right-hand flange of the KSU (refer to Figure 3-l). Then,
replace the screw you removed in Step 3.
Mount the Options Interface Hardware Unit to the right of the KSU on the
wooden backboard. Align the screw hole in the bottom left-hand comer of the
Options Interface Hardware Unit with the screw hole in the connection plate
(as shown in Figure 3-4). Fasten the Options Interface Hardware Unit to the
wooden backboard with the four wood screws.
There' s a short strip of black tape along the lower right-hand side of the KSU
that covers two ports. Starting at the top of the tape, peel it back to expose the
top port (refer to Figure 3-2). Cut off the excess tape.
Feature Module II & Options Interface Hardware
Page 12