Table of Contents
Advertisement
Trillium Standard Practice
Initial Installation
(for previously installed systems, go to the next section)
The following instructions detail initial installation of the Feature Module II
Cartridge.
CAUTION: Don' t plug in the KSU power cord until you are instructed to do so.
Step 1.
Step 2.
Step 3.
Step 4.
Step 5.
Step 6.
Step 7.
Step 8.
Mount the KSU as per the instructions
in the Installation and Commissioning
Practice
of the Panther II System Manual.
There are two small grooves on the Feature Module II Cartridge connector.
Holding the Feature Module II Cartridge so that the grooves are facing you,
plug it securely into the port on the KSU (refer to the close-up shown in Figure
2-l). Place the protective cover over the Feature Module II Cartridge,
push in
the plastic expansion plugs, and tighten the two screws.
Install the remainder of the system as outlined in the Installation and
Commissioning
Practice of the Panther II System Manual. After the system is
completely installed, includin, * the stations, plug in the KSU power cord. Ensure
the STATUS lamp on the side panel of the KSU is flashing.
Set the MEM. CLEAR Switch to the ON position.
The MEM. CLEAR Switch
(dipswitch #2) is located on the right-hand side panel of the KSU.
Press the RESET Switch.
Set the MEM. CLEAR Switch to the OFF position.
The system is now reset to
the default settings.
Set the Battery Switch for the KSU memory to the ON position.
The Battery
Switch (dipswitch #4) is located on the right-hand side panel of the KSU.
You must now program the system.
Refer to the Programming Practice in
the Panther II System Manual for instructions.
You' ll find programming
instructions
for the additional features provide by Feature Module II software in
this Practice.
Feature Module II & Options Interface
Hardware
Page 2
Advertisement
Chapters
Table of Contents
