Mitel Panther II 820 System Manual page 162

Trillium Standard Practice
2.0 4 Before programming the Panther II System, read all introductory material,
including "Selecting Preprogrammed Values" and "Modifying Preprogrammed
Values". Step through the Programming example provided. Although programming
can be completed in any order, it is recommended that System Programmmg be
completed first. The Programmable Keys subsection may be performed at the end,
after the system is operational, or on an individual user basis, as user's needs become
apparent. The following list indicates where specific programming codes are discussed
in this Practice.
SYSTEM PROGRAMMING:
General
- Hold Recall Tie
- Intercom on Hold
- Transfer Ringing Time
- Forced/Manual Account Code Digits
(4,6 or 8 digits)
- Executive Override Tone
- Time Display (12/24 Hr.)
- Call Forwarding Time
- Master Station Number
- Multiple Attendants
- Simultaneous/Serial Ringing
-
Camp-on Duration
- Camp-on Tone Interval
- System Clear
C-0. Specification
Type of Line
Behind PBXJCentrex
Loud Bell1
Relay Control
-
Make/Break Ratio
- Pulse Rate
- Interdigit Pause
- Tone Duration
- Tone or Pulse
- Telephone or PBXKentrex
- Pause on Number
- Pause Time
- Flash / Cancel / Transfer
- Flash/Cancel Timing
- Loud Bell or Relay Control
- Loud Bell Ringing by Line (Day Mode)
- Loud Bell Ringing by Line (Night Mode)
- Auto/Manual Relay Control
- Auto Return to Cff Timing
Programming
Page 2