Mitel Panther II 820 System Manual page 153

Trillium Standard Practice
Display Set will show the Hold Recall Reminder message. This message
consists of a call timer in the upper right comer (for external calls only), and
the words HOLD RECALL on the lower row, followed by the line (L) or
station (S) number that is being recalled.
LCD INTENSITY CONTROL
The LCD intensity control can be adjusted using a slider switch located on
the top of the LCD. This allows the Liquid Crystal Display to be viewed
under any lighting conditions, from either a standing or sitting position.
MESSAGE KEY
This key on the Panther II Display Set is used to program, confi'i and
cancel messages. Instructions for operation of this key are provided in the
Panther II Display Set User Guide.
MESSAGE WAITING DISPLAY
When the Intercom LED lights, indicating that a message is waiting to be
answered, the DISPLAY key must be pressed to show up to four station
numbers that left a message. Stations that left a message are shown on the
bottom row of the LCD in order of left to right, following the initials
"MW", with the leftmost station number corresponding to the oldest
message, and the rightmost station number corresponding to the newest
message. This display will remain until the DISPLAY key is pressed again.
Once a message has been answered, if the DISPLAY key is pressed again,
all remaining stations that left a message will shift one position to the left.
PAGING DISPLAY
If a user performs an EXTERNAL PAGE, ZONE PAGE or ALL PAGE
announcement from a Panther II Display Set, the LCD display will show the
type of Page being performed, on the top row. The 2-digit access code that
was dialed to achieve the Paging announcement will be shown on the
.
bottom left. For a ZONE PAGE, the Zone Group number will appear on
the top right of the display, following the intial "G". When the
announcement is complete, the LCD display will return to its idle state.
Features
and
Services
Page
60