Mitel Panther II 820 System Manual page 165

Panther II 820/1032/2064205
NOTES:
1. To correct an inputting error during Steps 2 and 3,
press the FLASH/CANCEL
key, and begin the procedure again at Step 2.
2.
To confirm what is programmed for a particular feature,
it is only necessary to
perform Steps 1,2, and 4 (in order). The programmed value for the
feature will be displayed on the LCD after Step 2. When confirmation
is completed, go to Step 6.
3. To confirm ailfeatures,
it is only necessary to perform Steps 1,2, and 4 (in order).
Keep pressing the # key to step through access codes. When
confirmation is completed, go to Step 6.
4.
To increment during access codes.
For some features such as Flexible Ringing
Assignment, it is helpful to be able to store all the line assignments for
a particular station before moving to the next station's access code. To
perform step programming such as this, press the HOLD key after
entering the appropriate data for the first line, station or group during
Step 3. This will increment the LCD Display to the next line, station or
group. Alternate between entering data and pressing the HOLD key
until all lines, stations or groups are programmed, and then continue
with Step 4.
PROGRAMMING EXAMPLE: SETTING HOLD RECALL TIME TO
1.5 MINUTES.
2.07 After entering programming mode at Station 10:
:
3:
4.
General System Programming
Locate the Hold Recall Tie parameters in Table 2-1.
Dial ACCESS CODE 000 (given in Table 2-l).
Dial the DATA CODE 3 (to change the recall time to 1.5 minutes).
Complete programming by dialing # to store the data, and then
dialing * to exit programming mode.
2.0 8 The General System parameters, including Access Codes and Data Codes are
provided in Table 2-1. (Refer to
Panther II 820/1032/2064-105, Features and Services
for more details.) They are:
HOLD RECALL TIME:
Defines the Hold Recall Time to be; no
reminder, or 30 seconds, 1 minute, 1.5 minutes, 2 minutes, 3 minutes,
or to remind the user after 3 minutes and then return the call to the
attendant after 5 minutes. The Hold Recall feature provides a reminder
of a call on hold by returning ringing to the set upon expiry of the Hold
Recall time.
Preprogrammed Value = No Reminder.
Programming
Page 5