Station Display; Display For Transfer Ringing To Attendant Station; Loud Bell Ringing/Ringing Over Paging By Line - Mitel Panther II 820 System Manual

Mite1 Standard Practise
Station Display
When you place a internal call from a Panther II Display set, the station that you' re
calling is indicated in the liquid crystal display. With Feature Module I or Feature
Module II software, the station is indicated by "Ext. XX", where XX is the station
number. With Feature Module IV software, the display has been changed to "Stn
xx".
EXAMPLE:
FM
I or FM II Software Display FM IV Software Display
Display for Transfer Ringing to Attendant Station
When a transfer ringing call is redirected to the Attendant Station, the liquid crystal
display on the Attendant Station' s Display Set identifies the station that the call was
initially transferred to, and the line that the call is on. For example:
1. An incoming external call on line 3 is answered at Station 13.
2. The person at Station 13 performs a ringing transfer to Station 14.
3. If the call isn' t answered at Station 14, it' s returned to Station 13.
4. If the call isn' t answered at Station 13, it' s sent to the Attendant Station.
5. The liquid crystal display on the Attendant' s Display Set appears as follows:
With Feature Module I or Feature Module II software, only the line number of the
incoming call is identified when a transfer ringing call is redirected to the Attendant
Station.
Feature Module IV software provides displays in English only.
VI pi
F' M
IV Software Display
FM I or FM II Software Display
Loud Bell Ringing/Ringing Over Paging By Line
The default value for the Loud Bell Ringing/Ringing Over Paging By Line feature
(Day mode: access code 063xX) is "Does NOT ring selected line during Day Mode"
(data code 1). In the previous software versions, Feature Module I and Feature Mod-
ule II, the default value for this feature is "Ringing selected line during Day Mode"
(data code 0).
Feature Module IV & On Premise Station Unit
Page 6
,'