Mitel Panther II 820 System Manual page 23

Mite1 Standard Practise
Step 7
Step 8
Step 9
Program the type of line select for the ONS stations:
'
From the Panther II Display Set at Station 10
Dial *#015 to enter programming mode
Dial access code 113YY where YY is the 2-digit station number of the ONS
device
Enter the desired data code:
0 for Auto Intercom (for a voice mail system)
2 for Manual Line Select (single line set or auto attendant)
Press the # key to store your selection
Repeat steps c to e for each ONS station
Press * to exit programming mode
Adjust the dipswitches located on the right-hand side of the ONS Unit to set the
duration of the Flash/Cancel Recognition (refer to Figure 3-5 and Table 3-8).
The duration of the Flash/Cancel Recognition should be set to the duration of
the flash/cancel signal that is produced by the ONS devices. Note that the
dipswitch settings determine the Flash/Cancel Recognition for all four ONS
stations (i.e., you can' t set a different Flash/Cancel Recognition for each ONS
station).
Plug in the ONS power cord. The ONS device (e.g., standard tone telephone)
begins working approximately 6 seconds after you plug in the ONS power cord.
CAUTION: The KSU must be receiving power when you plug in the ONS power
cord. If you plug in the ONS power cord before plugging in the KSU power
cord, the ONS unit will not work properly.
Feature Module IV & On Premise Station Unit
Page 18