Mitel Panther II 820 System Manual page 37

Mite1 Standard Practise
Example:
Display Set LCD
Step 5
Step 6
Repeat steps 2 to 4 for each type of call that you want the voice mail system to
recognize.
Press the
Speaker
key. The Intercom lamp turns off. The display returns to
showing the date and time.
Item
No. 9 in the Table 5-5, Message Waiting, is a DTMF digit string that' s sent from the
voice mail system to the ONS Unit. A caller, forwarded from a station to the station' s
voice mailbox, can leave a message. If the caller leaves a message, the voice mail system
will send this signal (default A) and the mailbox number to the ONS Unit. The ONS unit
converts the mailbox number into the appropriate station number and sends a message
waiting signal to the Panther station. The Intercom indicator lamp on the Panther set will
flash to indicate that there is a message waiting. If the mailbox number doesn' t come-
spond to a station, the Panther KSU sends busy tone to the voice mail system. Remem-
ber, the ONS station port that the voice mail system is connected to, must be programmed
for Auto Intercom select, or a Message Waiting signal won' t be sent to the Panther set.
To confum the digit strings that you' ve stored:
Step 1 Press the
Display
key on the Panther II Display Set at the Master Attendant
Station. The Intercom lamp turns on steady and the display is blank.
Step 2 Press the
Speed
key.
Step
3
Enter the 3-digit code (from Table 5-5) that corresponds to the type of call
(e.g., #SO). The digit string stored for that code will be displayed.
Example:
Display Set LCD
Step 4
Step 5
Repeat steps 2 and 3 for each digit string that you wish to confirm.
Press the
Display
key. The Intercom lamp turns off. The display returns to
showing the date and time.
Feature Module IV & On Premise Station Unit
Page 32