Requirements; Installation And Setup; Cleaning The 6873I Touchscreen - Mitel 6873i User Manual

WELCOME
Wideband handset
•
Wideband, full-duplex speakerphone for handsfree calls
•
USB, Bluetooth headset and Bluetooth cordless handset support
•
AC power adapter (sold separately)
•
Enhanced busy lamp fields*
•
Set paging*
•
*Availability of feature dependent on your phone system or service provider.

REQUIREMENTS

The 6873i requires the following environment:
SIP-based IP PBX system or network installed and running with a SIP account created for the 6873i
•
phone
Access to a Trithroughl File Transfer Protocol (TFTP), File Transfer Protocol (FTP), Hypertext Transfer
•
Protocol (HTTP) server, or Hyper Text Transfer Protocol over Secure Sockets Layer (SSL) (HTTPS)
Ethernet/Fast Ethernet LAN (10/100 Mbps) (Gigabit Ethernet LAN [1000 Mbps] reco mended)
•
Category 5/5e straight-through cabling (Category 6 straight-through cabling required for optimum
•
Gigabit Ethernet performance)
The USB drive file system is set as FAT32 for the USB to be detected by the phone.
•
Power source:
•
For Ethernet networks that supply inline power to the phone (IEEE 802.3af or IEEE 802.3at [IEEE
–
802.3at recommended]) use an Ethernet cable to connect from the phone directly to the network for
power (no 48V AC power adapter required if using Power-over-Ethernet [PoE] or PoE plus)
For Ethernet networks that DO NOT supply power to the phone:
–
Use only the GlobTek Inc. Limited Power Source [LPS] adapter model no. GT-41080-1848 (sold
•
separately) to connect from the DC power port on the phone to a power source or
Use a PoE power injector or a PoE switch (PoE plus reco mended)
•

INSTALLATION AND SETUP

If your System Administrator has not already setup your 6873i phone, please refer to the Mitel 6873i
Installation Guide for basic installation and physical setup information. For more advanced administra-
tion and configuration information, System Administrators should refer to the Mitel SIP IP Phones
Administrator Guide.

CLEANING THE 6873I TOUCHSCREEN

Repeated use of the 6873i touchscreen may lead to a dirty screen. To clean the phone's screen, Mitel
recommends the use of a super fine cotton cloth, cotton swab, or microfiber lens cloth made of microfiber
suede (preferably one without sewn hems or similar characteristics that would scratch the surface of the
screen). You can use the cloth dry for dusting, polishing and light cleaning, or dampen it (with water only)
to deep clean the surface. If using a damp cloth, make sure to use just a little water on the cloth. Too much
REQUIREMENTS
2