Mitel Panther II 820 System Manual page 132

Panther II 820/1032/2064-105
Programming Required
None
HANDSFREE ANSWERBACK
Description
When an intercom call (by voice) is placed to a Non-Handsfree Set, if the
user's microphone is on, the user can have a handsfree conversation simply
by speaking in the direction of the Set.
Conditions
l
All Non-Handsfree Sets except the Panther II Set have Handsfree
Answerback on intercom.
Programming Required
None
INCOMING CALLS
Description
Incoming calls are defmed as calls which are received over C.O. lines.
The
presence of an incoming call is indicated by audible ringing and/or a
flashing line indicator.
If Ringing Line Preference is programmed for the Set (see Section 4,
RINGING LINE PREFERENCE), the ringing call can be picked up by
simply lifting the handset (or pressing the SPEAKER key, if handsfree), or
dialing 9. If Ringing Line Preference is not programmed, the ringing call
can be picked up by pressing the flashing line indicator. Panther II Sets
should be programmed with Ringing Line Preference.
Conditions
In order for ringing to occur, ensure that the following options are
programmed correctly:
Ringing must be programmed for the line that the call is coming in on (see
Section 4, FLEXIBLE RINGING ASSIGNMENT).
Do Not Disturb cannot be activated at the Set (see Section ,5, DO NOT
DISTURB).
If
the Set belongs to Tenant Type B or D, only C.O. lines within the same
Tenant Group can be accessed (see Section 4, TENANT TYPES).
Ringing will follow either Simultaneous or Serial programming (see
Section 4, DISCRIMINATING RINGING).
C.O. calls have priority over Intercom calls, if both ring in at the same _
time.
Features
and Services
Page 39