Mitel Panther II 820 System Manual page 246

Electronic key telephone system
Table of Contents

Advertisement

Panther
II 820/1032/2064-200
Panther
Telephone
Set Installation
6.0 9
Installation of a Panther telephone set simply requires the set to be connected,
through the DBU4 (6conductor
mod-to-mod
cord) supplied with the set, to the
previously-installed
RJ14C jack. Note:
If the 'Off-Hook Voice Announce'feature is
used on the Panther II Display Set, a 6-conductor cable and jack is required for that
station. Remember that this feature occupies two station ports; for example, tf
Station
12 has 'Off-Hook Voice Announce', Station I3 will be unavailable for use as a station.
Figure 6-9 shows how to install 'Off-Hook Voice Announce' on a Panther II Display
Set.
The
Panther telephone set may be wall mounted, or raised on the desk using the
Desk/Wall Mount Unit (Pa.& 90-0059).
To mount a Panther telephone set on the wall
complete the following instructions:
Step 1.
Step 2.
Place the Desk/Wall Mount Unit on the wall at the desired location.
Mark the position of the keyhole slots.
Install the appropriate mounting screws, allowing sufficient clearance
for the Desk/Wall Mount Unit to slide between the head. of the mounting
screws and the wall.
Step 3
Before hanging the Panther telephone set on the screws, install a
handset clip. This clip keeps the handset in the crrrdle in wall-mount
applications
(do not use handset clips on desk-top telephones).
To
install the clip, position it so that the flat side is facing you and the
angled side is toward the set. Insert the clip. To remove, use a paper
clip or similiar tool. Refer to Figure 6-8.
Side view of clip
Bade
Front
(x2 enlargement)
Figure
6-8
Handset
Clip Installation
Step 4.
Step 5.
Hang the Desk/Wall Mount Unit on the mounting
screws. Tighten the
mounting
screws.
Rest the Panther telephone set on the Desk/Wall Mount Unit
See
Figure 6-10.
Installation
and Commissioning
Page 27

Advertisement

Table of Contents
loading

Table of Contents