Mitel Panther II 820 System Manual page 154

Panther II 820/1032/2064-105
PERSONALIZED MESSAGES
Each Panther II Display Set user can program a personal message to appear
when other Panther II Display Set users call them; e.g., CONE TO LAB.
One message per user is allowed, and the message can be up to 16
characters in length, including spaces, numbers and special symbols. The
message is entered from the keypad, using the methods explained in the
Panther II Display Set Guide. The message will remain activated until the
user cancels it.
PROGRAM KEY
The PROGRAM key on the Panther II Display Set is used to enter
Programming Mode.
SAVED NUMBER REDIAL KEY
The SAVED NUMBER REDIAL key is pressed to store a telephone
number for repeated short-term use. The key is also pressed when the user
wishes to dial the number that has been stored. The stored number will be
retained in memory until another telephone number replaces it. The stored
number can be viewed using the DISPLAY key (see DISPLAY KEY in this
Section).
SECURE NUMBER DISPLAY
When the PROGRAM key is pressed at the appropriate point during a
Private Speed Call Storing operation, the SECURE NUMBER feature will
be enabled and privacy will be enforced for the specific telephone number.
This means that when the Speed Call Number is dialed at a later time, the
LCD display will not show the digits that were saved in memory. Instead,
the LCD will display the line number used and call duration on the top row,
and the Secure Number will appear on the bottom row as question marks (?).
SPEED DIAL DISPLAY
When a Private or Common Speed Dial number is dialed, either by code, or
pressing the appropriate DSS key, the LCD display will show the telephone
number that was stored in the code's location. The stored telephone number
will not appear if SECURE NUMBER DISPLAY is active (see above).
Features and Services
Page 61