Mitel Panther II 820 System Manual page 68

Panther II 820/1032/2064-296
You can program each of the incoming DISA lines separately for Day or Night Mode
operation. Each of the lines can have one of four possible settings:
l
Day off/Night off - DISA won' t work during the Day or Night Mode (default setting),
l
Day on/Night off - DISA will work only during Day Mode,
l
Day off/Night on - DISA will work only during Night Mode, or
l
Day on/Night on - DISA will work during both Day and Night Mode.
You can also change the default setting of the release time for the DISA feature. The
release time determines the length of time allowed for an external call made using the
DISA feature. Note that the length of time you select also determines the release time
for the ECF feature.
In summary, the parameters that you must program for DISA are:
incoming lines for DISA,
the DISA access codes,
Day/Night Mode for incoming line 1,
Day/Night Mode for incoming line 2 (if programmed), and
the DISA/ECF release time.
Follow the procedure listed below to program the system for DISA:
Step 1.
Step 2.
Step 3.
Step 4.
Step 5.
At Station 10, dial *# (or press the Program key).
Dial 015.
Program the incoming DISA lines:
a.
Dial access code 0300=Xx where XX=the number of the line desired for incoming DISA
line 1.
b. Dial # to store the line number.
If
a second incoming DISA line is desired,
c. ~~~~es.s
code 0301=Xx where XX=the number of the line desired for incoming DISA
d. Dial #' to store the line number.
Default: No lines programmed for DISA.
Note: Later, you may want to disable DISA. To disable DISA line 1 enter access code 0300=00
in step a. To disable DISA line 2, enter access code 0301=00 in step c.
Program the desired
DISA access codes:
a. Dial 029OXXXX#
where XXXX=the desired 4-digit code for the fit
DISA access code.
b. Dial 0291XXXX# where XXXX=the desired 4-digit code for the
second DISA access code.
c. Dial 0292XXXX# where XXXX=the desired I-digit code for the third DISA access code.
d. Dial 0293XXXX# where XXXX=the desired 4-digit code for the fourth DISA access code.
Default: No codes.
Program
the Day/Night Mode selection for incoming DISA line 1.
a. Dial access code 0380.
b. Dial data code 0 for Day off/Night off (default setting),
1 for Day on/Night off,
2 for Day off/Night on, or
3 for Day on/Night on.
c. Dial # to store your selection.
Feature Module II & Options Interface Hardware
Page 19