Mitel Panther II 820 System Manual page 203

Panther II 820/1032/2064-205
GROUP PROGRAMMING
General by Line
2.2 0 The
Group Parameters, including Access Codes and Data Codes are provided in
Tables 2-15 to 2- 18. The parameters are:
TENANT GROUP ASSIGNMENT:
Up to 8 lines on the Panther
II 820 system, or 10 lines on the Panther II 1032 system, or 20 lines
-on the Panther II 2064 system are put into one of 15 Tenant Groups.
Use Table 2-15 to check off which lines are to be included in each
group from 01 to 15. Note: A line can be in more than one tenant
group.
2.2
1
After filling in your Tenant Group Assignment selections in Table 2-15:
Step 1.
At Station 10 (using a Panther II Display Set), dial * # 0 1 5.
Step
2. Dial 20122 (where 22 is a 2-digit group number from 01 to
15).
Step 3.
Step 4.
Dial XX (where XX is a 2-digit line number from 01 to 20).
Dial the digit
1,
if you want the selected line in the selected
group,
OR
Dial the digit 0, if you do
not
want the selected line in the
selected group.
Step 5.
After the inputted data is displayed, press the
HOLD
key to
store the data and increment to the next line.
Step
6. Repeat Steps 4 and 5 until all lines in a particular group are
programmed, then
l
Press the HOLD
key to increment to the next group number,
OR
l
Press #
to store all previous data or dial a new access code.
Step 7. Press
the *key to exit programming when all selections have
been made. The new programming is complete.
Programming
Page 43