Mitel Panther II 820 System Manual page 73

Trillium Standard Practice
Panther II System
ECF Incoming
Feature Module II
Outgoing ECF
System dials speed
Line 1
call stored in common
Caller dials telephone
number of incoming
line 1.
speed call coda 98.
System dials speed
call stored in common
speed call code 99.
Caller dials telephone
number of ECF incoming
Line 2.
Call rings telephone
set at the stored number,
Call rings telephone
set at the stored number.
Figure 3-5 External Call Forwarding
Operating Notes
l
External call forwarding is enabled at the Master Attendant Station by dialing "08
1
and disabled by dialing *080.
l
Trunk to Trunk Conferences, External Call Forwarding and external calls using Direct
Inward System Access each use two amplified lines. The Options Interface Hardware
Unit only has the capability of providing four amplified lines at any given time.
Therefore, if all four amplified lines are being used, when you call in on the incoming
ECF line, you will hear continuous ringing. You must hang up and try again.
l
Since the Options Interface Hardware Unit can' t create HALTS or PAUSES, the ECF
feature can' t be used behind Private Branch Exchanges (PBXs) that require HALTS or
PAUSES in dialing sequences.
l
Don' t use ECF lines to make outgoing calls from the office because this will tie up the
ECF lines. A person calling in to a busy ECF line will hear busy tone. If the outgoing
ECF line is busy, the person calling in on the corresponding incoming ECF line will
hear continuous ringing.
Feature Module II & Options Interface Hardware
Page 24