Mitel Panther II 820 System Manual page 173

Panther II 820/1032/2064-205
C.O. Line Specification Proiramming
2.0 9 The C.O. Specification parameters, including Access Codes and Data Codes are
provided in Table 2-3. They are:
MAKE/BREAK RATIO: Defines the on/off ratio of pulses used for
pulse dialing; either 33% or 40%.
Note:'33% is not permitted when equipment is to be installed in North America
and connected to the North American Telephone Network.
Preprogrammed Value = 40%.
PULSE RATE: Defines the speed at which pulse digits are dialed
out; either 10 pps or 20 pps (pps represents pulses per second).
Note: 20 pps is not permitted when equipment is to be installed in North America
and connected to (he North American Telephone Network,
Preprogrammed Value = 10 pps.
INTERDIGIT PAUSE: Defines the time between pulse-dialed
digits as 500 ms, 700 ms, 800 ms or 1100 ms (ms represents
milliseconds).
Note: 500 ms is not permitted when equipment is to be installed in North
America and connected to the North American Teiephone Network.
Preprogrammed Value = 800 ms.
TONE DURATION: Determines the length of each tone digit
dialed. Length can be 50 ms, 75 ms, 100 ms or 200 ms.
Preprogrammed Value = 75 ms.
Programming
Page
13