Mitel Panther II 820 System Manual page 212

Trillium Standard Practice
ZONE PAGING GROUPS: In order to perform the Zone Paging
feature on the Panther II system, each station must be assigned to at
least one of the fifteen 2-digit pickup groups (01 to 15). Paging groups
can be organized by department, function or proximity.
I
Preprogrammed Value = No Zone Paging Groups.
2.2 5 To set up Zone Paging Groups:
Step 1.
At Station 10 (using a Panther II Display Set), dial * # 0 1 5.
Step 2.
Dial 122YY (where YY is a 2-digit station number from 10 to
73).
Step 3.
Dial 22 (where ZZ is a 2-digit Zone Paging Group from 01 to
15).
Step 4.
Dial the digit 0, if you do not want the selected station to be
included in the selected Zone Paging group,
OR
Dial the digit 1, if you want the selected station to be included in
the selected Zone Paging group.
Step 5.
After the inputted data is displayed, press the HOLD key to
store the data and increment to the next Zone Paging Group.
Step 6.
Repeat Steps 4 and 5 until all zones at the particular station are
elected, then
l
Press the HOLD key to increment to the next station number,
OR
l
Press # to store all previous data or dial a new access code.
Step 7. Press the * key to exit programming when all selections have
been made. The new programming is complete.
INTERCOM TENANTING / STATION HUNT GROUPS:
(Table 2-20) This programming code allows all stations to be placed
into one of four groups for Intercom Tenanting or Station Hunting
purposes. Refer to
Panther II
820/I 032/2064-105,
Features and
Services
for more details. Each station can be placed in only one
group. If the four groups must be able to communicate with each
other, ensure that the system has been changed to Non-Private Mode
(as described in System Programming). See also MULTIPLE
ATIENDANTS - System Programming, if sub-attendants will be
linked to each group.
Programming
Page 52