Mitel Panther II 820 System Manual page 230

Panther II 820/1032/2064-200
TOOLS:
Screwdrivers
Punch Down Tool
Staple Gun
EQUIPMENT:
APPLICATION:
Mounting major components
Terminating MDF cables
Securing cables
Modular Jacks
Connecting Stations
50-pin 'D' Amp Connector
KSU to MDF Cable termination
MDF (BIX or 66 Block)
Main Distribution Frame
Surge Protector
Lightning protection at mains ac
Ground Wire (12 AWG)
Grounding the KSU
Modular-to-Modular Cords
Equipment interconnection
4-wire Cable (24 AWG)
Station wiring
Table 5-l Installation Tools and Equipment
6. INSTALLATION PROCEDURES
General
6.0
1 The
installation procedures given in this subsection detail the installation of the
major components of the Panther II 820, 1032 and 2064 systems along with the
ancillary devices which may be incorporated. The interconnection of the complete
system and its anciliary devices is shown in Figure 6-l.
Delivery Check
6.0 2 Upon receipt of the Panther II system, the quantity and type of items received,
should be checked against the purchase order. Any discrepancy should be reported to
the supplier immediately.
Unpacking and Inspection
6.0 3 After the delivery check is complete, each item of equipment should be
unpacked, in accordance with the unpacking instructions located on the outside of the
equipment boxes, and inspected for transit damage. Any discrepancy should be
reported to the supplier_immediately.
Installation and Commissioning
Page 11