Mitel Panther II 820 System Manual page 234

Panther II 820/1032/2064-200
Mounting System
Components
6.0 4
The following instructions detail the installation of the KSU. The installation
procedure is similar for any ancillary devices included in the system, only the location
of the mounting screws may differ. This can be seen in Figures 6-2 to 6-6.
Step 1. Using suitable fasteners, mount a wooden backboard, of sufficient size
to accommodate the KSU and ancillaq devices (if any), to the wall,
within 4 feet of the ac outlet and at least 12 inches (305 mm) above the
floor. Allow room for installation of the ancillary devices which may be
installed at a later date.
Step 2. Position the KSU on the backboard. Mark the positions of the KSU's
four mounting screws on the backboard.
Step 3. Install the mounting screws supplied, into the backboard, leaving
approximately an 0.2 inch (5 mm) gap between the back of the screw
head and the backboard.
Step 4. Hang the KSU on the mounting screws. Tighten the mounting screws.
Caution:
Do not connect the KSU power cord until instructed to do so.
I
Step 5. Repeat Steps
1
through 4 for each of the ancillary devices to be
installed.
Installing the Feature Module Cartridge
6.0
5
Panther II 820 and 1032 Key Service Units have a Feature Module Cartridge
that contains the software for the Panther II features.
Step 1. Unpack the Feature Module Cartridge. An information sheet packed
with the Feature Module Cartridge provides an installation diagram.
Step 2. There are two small grooves on the Feature Module Cartridge
connector. Holding the Feature Module Cartridge so that the grooves
are facing you, plug it into the port that is located halfway down the
right-hand side of the KSU.
Step 3. Place the protective cover over the Feature Module Cartridge, push in
the plastic expander plugs, and tighten the two screws.
Installation and Commissioning
Page 15