Installing A T320 Pc Card; Replacing A Dimm Module In T320 Routing Engines; Figure 84: Installing A Pc Card - Juniper T320 Hardware Manual

T320 Core Router Hardware Guide

Replacing a DIMM Module in T320 Routing Engines

166

Installing a T320 PC Card

To install a PC card (see Figure 84 on page 166):
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis. For more information about ESD,
see "Preventing Electrostatic Discharge Damage to a T320 Router" on page 210.
If the Routing Engine cover is in place, remove the cover by loosening the captive
2.
screws on the corners of its faceplate.
Insert the PC card into the PC card slot on the Routing Engine, with the Juniper
3.
Networks logo facing downward.
CAUTION: Be sure to insert the PC card with the label facing downward.
Inserting the PC card incorrectly might damage the Routing Engine.
NOTE: The Routing Engine in your router might have two PC Card slots.
In this case, use either slot. Do not install more than one PC card in the
Routing Engine.
Press the card firmly all the way into the slot.
4.
Reinstall the Routing Engine cover and tighten the screws on the corners of the cover
5.
to secure it to the chassis.

Figure 84: Installing a PC Card

Removing a T320 DIMM Module on page 167
1.
Installing a T320 DIMM Module on page 167
2.
Copyright © 2010, Juniper Networks, Inc.