Installing A T4000 Lcc-Cb; Figure 98: Removing An Lcc-Cb - Juniper T4000 Hardware Manual

Installing a T4000 LCC-CB

Copyright © 2013, Juniper Networks, Inc.

Figure 98: Removing an LCC-CB

To install an LCC-CB (see
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
1.
the strap to one of the ESD points on the chassis.
Verify that the two configuration switches on the faceplate of the LCC-CB are set
2.
correctly for a standalone T4000 router before you install the LCC-CB:
The configuration switch must be set to
M/S
The configuration switch must be set to
CHASSIS ID
Carefully align the sides of the LCC-CB with the guides inside the chassis.
3.
Slide the LCC-CB into the chassis, carefully ensuring that it is correctly aligned.
4.
Grasp both ejector handles, and press them inward to seat the LCC-CB.
5.
Tighten the captive screws on the ejector handles, using a Phillips (+) screwdriver,
6.
number 2.
Verify that the LCC-CB is functioning normally:
7.
Check the LEDs on the LCC-CB faceplate. The green
a few minutes after the LCC-CB is installed. If power is applied to the Routing Engine
and its corresponding LCC-CB is functioning normally, the LCC-CB comes online
automatically.
If the LED is lit steadily, remove and install the LCC-CB again. If the
FAIL
still lights steadily, the LCC-CB is not functioning properly. Contact your customer
support representative.
Chapter 19: Replacing T4000 Router Hardware Components
Figure 99 on page 231):
.
S
.
0
LED should light steadily
OK
LED
FAIL
229