Configuring Client-Side Logs (Nsm Procedure); Configuring The Infranet Controller As An Snmp Agent (Nsm Procedure) - Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING INFRANET CONTROLLER GUIDE REV 01 Manual

NSM Infranet Controller Configuration Guide

Configuring Client-Side Logs (NSM Procedure)

Related
Documentation

Configuring the Infranet Controller as an SNMP Agent (NSM Procedure)

216
Configuring User Access Logs (NSM Procedure) on page 213
Configuring Event Logs (NSM Procedure) on page 212
Configuring the Infranet Controller as an SNMP Agent (NSM Procedure) on page 216
You can enable client-side logging for the Host Checker and Odyssey Access Client. When
you enable this option, the Infranet Controller writes a client-side log to endpoints that
use the feature. The Infranet Controller appends to the log file each time the feature is
invoked during subsequent user sessions. This feature is useful when working with the
support team to debug problems with the respective feature.
To configure client-side logs:
In the NSM navigation tree, select Device Manager> Devices.
1.
Click the Device Tree tab, and then double-click the Infranet Controller for which you
2.
want to specify global client-side logging settings.
Click the Configuration tab. In the configuration tree, select System > Log/Monitoring
3.
> Client Logs > Settings.
Select the features for which you want the Infranet Controller to write client-side logs.
4.
Click one:
5.
OK—Saves the changes.
Cancel—Cancels the modifications.
Configuring the Infranet Controller as an SNMP Agent (NSM Procedure) on page 216
Configuring User Access Logs (NSM Procedure) on page 213
Configuring Administrator Access Logs (NSM Procedure) on page 214
Configuring Event Logs (NSM Procedure) on page 212
The Infranet Controller supports Simple Network Management Protocol version 2
(SNMPv2), implements a private MIB, and defines its own traps. To enable your network
management station to process these traps, you need to download the Juniper Networks
MIB file and specify the appropriate information to receive the traps.
To specify SNMP settings:
In the NSM navigation tree, select Device Manager> Devices.
1.
Click the Device Tree tab, and then double-click the Infranet Controller for which you
2.
want to specify SNMP settings.
Copyright © 2010, Juniper Networks, Inc.