Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING INFRANET CONTROLLER GUIDE REV 01 Manual page 217

Related
Documentation
Copyright © 2010, Juniper Networks, Inc.
IF-MAP Variables: This node consists of IF-MAP variables. Double-click a IF-MAP
variable to display its description and example usage. Click the IF-MAP variable
example to insert it in the Expression area.
Juniper IDP Variables: This node consists of Juniper IDP variables. Double-click a
Juniper IDP variable to display its description and example usage. Click the Juniper
IDP variable example displayed to insert it in the Expression area.
NOTE: Refer to the Juniper Networks Unified Access Control Administration
Guide for more information on variables and writing custom expressions.
Enter a name for the custom expression.
6.
Select a variable or prebuilt expression from the Custom Dictionary, and click Insert
7.
Expression. The expression is displayed in the Expression area on the right side of the
Custom Expression editor. The conditional operators can be selected only after a leaf
node is selected.
Click the Validate button to validate the expression. The expression is validated by
8.
the device and the validation status appears.
NOTE: You can create a custom expression in a device template, but you
cannot validate the custom expression. The Validate button is not enabled
in the Custom Expressions editor of device templates.
Click OK to save the custom expression. The new custom expression is displayed
9.
under the Sensor Events tab.
Click OK to save the sensor events settings.
10.
Configuring Sensor Event Policies (NSM Procedure) on page 196
Configuring ISG-IDP as a Sensor on the Infranet Controller (NSM Procedure) on page 193
Configuring Infranet Controller Sensor Settings for Connecting to a Standalone IDP
Device (NSM Procedure) on page 194
Chapter 18: Configuring the Infranet Controller to Interoperate with IDP
199