Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING INFRANET CONTROLLER GUIDE REV 01 Manual page 64

NSM Infranet Controller Configuration Guide
46
Table 8: OAC Configuration Details (continued)
Option Function
Configure wired Configures a wired
adapter adapter to use for wired
access to the Infranet
Controller at a later time,
if the user is accessing the
Infranet Controller through
a wireless adapter during
Odyssey Access Client
installation.
Configure Specifies the network
wireless adapter settings you want to
configure in Odyssey
Access Client for wireless
adapters.
Network name Specifies the network
(SSID) name.
Association Specifies the association
mode mode you want Odyssey
Access Client to use when
associating to the access
point hardware on your
network.
Your Action
Select the option.
Select the wireless adapter option. The Network
name (SSID) option, Association mode option
and Encryption method option are enabled only
if the wireless adapter option is selected.
Enter the network name, which can use up to 32
alphanumeric characters and is case-sensitive.
You must enter the name correctly to connect
successfully. For example: <MyCorpNet>.
Select the association mode:
open—Connects to a network through an
access point or switch that implements
802.1X authentication. Select this mode if
users are not required to use shared mode or
Wi-Fi Protected Access (WPA).
WPA—Connects to a network through an
access point that implements WPA.
WPA2—Connects to a network through an
access point that implements WPA2, the
second generation of WPA that satisfies
802.11i.
Copyright © 2010, Juniper Networks, Inc.