Device - Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING INFRANET CONTROLLER GUIDE REV 01 Manual

Configuring and Enabling the DMI Agent on the Infranet Controller Device
Copyright © 2010, Juniper Networks, Inc.
From the Choose Device Server Connections Parameter area, select:
6.
Use Default Device Server IP Address and Port—Connects the device to the NSM
device server IP address and port.
Use Device Server Through MIP—Connects the NSM device server through a mapped
IP address and port.
Click Next, and a unique external ID gets generated automatically. This ID represents
7.
the device within the management system.
Enter an admin username for the device admin.
8.
Set the Admin User Password and the First Connection One-Time Password:
9.
Select Set Password and enter a new password.
a.
Confirm your new password and click OK.
b.
NOTE:
Make a note of the unique external ID. The device administrator will
need it to configure connectivity with NSM. The wizard automatically
enters this value for the device. This ID number represents the device
within the management system.
Specify the administrator username and password for the SSH
connection. This name and password must match the name and
password already configured on the device.
Specify the First Connection One Time Password (OTP) that
authenticates the device. Make a note of this password. The device
administrator will need it to configure the connectivity with NSM.
Click Finish to add the device to the NSM UI. The Infranet Controller appears in the
10.
Devices workspace.
You must configure and activate the DMI agent on the Infranet Controller device. It helps
to establish SSH communications with the NSM application and to control the Infranet
Controller from the NSM application.
To configure and enable the DMI agent:
Select System > Configuration > DMI Agent to add the NSM management application.
1.
Under DMI settings for outbound connections, enter the device server's IP address in
2.
the Primary Server box..
Enter 7804 in the Primary Port box.
3.
Fill in the Backup Server and Backup Port boxes, if a device server is configured for
4.
high availability.
Chapter 3: Adding Infranet Controllers
13