Configuring Infranet Controller Sensor Settings For Connecting To A Standalone Idp Device (Nsm Procedure); Creating An Idp Device Entry - Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING INFRANET CONTROLLER GUIDE REV 01 Manual

NSM Infranet Controller Configuration Guide
Related
Documentation
Configuring Infranet Controller Sensor Settings for Connecting to a Standalone IDP
Device (NSM Procedure)

Creating an IDP Device Entry

194
Select 1-Info through 5-Critical from the IDP Severity Filter drop-down list. The severity
7.
filter allows you to specify the level of attacks that the Infranet Enforcer reports to
the Infranet Controller. For example, if you select 3, only level 3 attacks or greater is
reported.
Click one:
8.
OK—Saves the changes.
Cancel—Cancels the modifications.
Configuring Infranet Controller Sensor Settings for Connecting to a Standalone IDP
Device (NSM Procedure) on page 194
Configuring Sensor Event Policies (NSM Procedure) on page 196
You can specify system settings that the Infranet Controller uses to establish a connection
to a Juniper Networks Intrusion Detection and Prevention (IDP) device. The sensor settings
allow you to perform a number of tasks related to configuring and managing interaction
between the Infranet Controller and an IDP device.
Creating an IDP Device Entry on page 194
1.
Enabling or Disabling the Connection to an Existing IDP Device on page 195
2.
In IDP versions prior to 5.0, the Infranet Controller sends only the user IP address. With
version 5.0, the Infranet Controller sends session information including the user, role, and
IP address. This allows you to configure more granulated IDP policies based on roles in
IDP.
To create an IDP device entry:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device Tree tab, and then double-click the Infranet Controller device on
2.
which you want to configure a new IDP device entry.
Click the Configuration tab. In the configuration tree, select System > Configuration
3.
> Sensors.
Select the Sensors tab. The corresponding workspace appears.
4.
Add or modify settings as specified in Table 56 on page 195.
5.
Click one:
6.
OK—Saves the changes.
Copyright © 2010, Juniper Networks, Inc.