Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING INFRANET CONTROLLER GUIDE REV 01 Manual page 161

Copyright © 2010, Juniper Networks, Inc.
Table 45: Infranet Controller eTrust SiteMinder Configuration
Details (continued)
Option
Poll Interval (seconds)
Maximum Agents
Maximum Requests/Agent
Idle Timeout (minutes)
Authorize while
Authenticating
Chapter 13: Configuring Authentication Servers
Function Your Action
Specifies the interval at Enter the poll interval in seconds.
which Infranet Controller
polls the SiteMinder policy
server to check for a new
key.
Specifies the maximum Enter a number.
number of simultaneous
connections that the
Infranet Controller is
allowed to make to the
policy server.
NOTE: The default setting
is 20.
Specifies the maximum Enter a number.
number of requests that
the policy server
connection handles before
the Infranet Controller
ends the connection. If
necessary, tune to
increase performance.
NOTE: The default setting
is 1000.
Specifies the maximum Enter the Idle timeout in minutes.
number of minutes a
connection to the policy
server may remain idle
(the connection is not
handling requests) before
the Infranet Controller
ends the connection. The
default setting of "none"
indicates no time limit.
Specifies that the Infranet Select Siteminder Settings >
Controller should look up Advanced > Authorize while
user attributes on the Authenticating.
policy server immediately
after authentication to
determine if the user is
truly authenticated.
143