Removing An Infranet Controller From Nsm Management (Nsm Procedure); Deactivating A Dmi Agent In An Infranet Controller (Nsm Procedure) - Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING INFRANET CONTROLLER GUIDE REV 01 Manual

NSM Infranet Controller Configuration Guide

Removing an Infranet Controller from NSM Management (NSM Procedure)

Related
Documentation

Deactivating a DMI Agent in an Infranet Controller (NSM Procedure)

Related
Documentation
190
Deleting a device removes all device configuration information from the management
system, but might be the best solution if you need to perform extensive troubleshooting
or reconfigure the device locally.
To remove an Infranet Controller from NSM management:
In the NSM navigation tree, select Device Manager> Devices.
1.
Click the Device Tree tab.
2.
From the device tree, select the Infranet Controller device that you would like to remove
3.
from NSM management.
Right-click and select Delete, or click the Delete button. The Delete dialog box appears.
4.
If the device is referenced in a firewall rule, this dialog box displays the rules that
reference it. You can click the links that appear to display the security policies to view
or edit those references.
Remove the device by clicking Next. The Delete dialog box displays the progress of
5.
the deletion.
After NSM finishes, click Finish to close the dialog box.
6.
Deactivating a DMI Agent in an Infranet Controller (NSM Procedure) on page 190
Importing an Infranet Controller Device Through Not Reachable Workflow on page 11
Adding an Infranet Controller Cluster with Imported Cluster Members on page 24
To deactivate the DMI Agent in an Infranet Controller:
In the NSM navigation tree, select Device Manager> Devices.
1.
Click the Device Tree tab.
2.
From the device tree, select the Infranet Controller device in which you would like to
3.
deactivate the DMI agent.
Click the Configuration tab. In the configuration tree, select System > Configuration
4.
> DMI Agent.
In the DMI Agent page, clear the Enabled check box.
5.
Click one:
6.
OK—Saves the changes.
Cancel—Cancels the modifications.
Removing an Infranet Controller from NSM Management (NSM Procedure) on page 190
Copyright © 2010, Juniper Networks, Inc.