Configuring An Infranet Controller Rsa Ace/Server Instance - Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING INFRANET CONTROLLER GUIDE REV 01 Manual

Related
Documentation
Configuring an Infranet Controller RSA ACE/Server Instance (NSM Procedure)
Copyright © 2010, Juniper Networks, Inc.
button. The prebuilt expression is displayed in the Expression area. Modify the values
to create your own custom expression.
Variables: This node consists of variables. When a variable is selected, the conditional
operators that can be applied to this variable are listed in the center of the Custom
Expressions editor. Also, some variables have extensions that are displayed in the
drop-down list next to the variable. Double-click a variable to display its description
and example usage. Click the example variable to insert it in the Expression area.
Your Expressions: This node consists of expressions that you created for a particular
server catalog. To reuse an existing expression, select the expression and click the
Insert Expression button.
NOTE: Refer to the Juniper Networks Unified Access Control Administration
Guide for more information on variables and writing custom expressions.
Enter a name for the custom expression.
6.
Select a variable or prebuilt expression from the Custom Dictionary, and click Insert
7.
Expression. The expression is displayed in the Expression area on the right side of the
Custom Expression editor. The conditional operators can be selected only after a leaf
node is selected.
Click the Validate button to validate the expression. The expression is validated by
8.
the device and the validation status appears.
NOTE: You can create a custom expression in a device template, but you
cannot validate the custom expression. The Validate button is not enabled
in the Custom Expressions editor of device templates.
Click OK to save the custom expression. The new custom expression is displayed
9.
under the Expressions tab of the server catalog.
Click OK to save the auth server settings.
10.
Creating a Custom Expression for Sensor Settings (NSM Procedure) on page 198
The RSA ACE/Server, which is supported by the Infranet Controller, is used to authenticate
users. If the ACE/Server positively authenticates the user, the user gains access to the
Infranet Controller.
Chapter 13: Configuring Authentication Servers
119