Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING INFRANET CONTROLLER GUIDE REV 01 Manual page 89

Copyright © 2010, Juniper Networks, Inc.
To configure the number of concurrent sessions and concurrent users for Infranet
Controller users:
In the NSM navigation tree, select Device Manager > Devices.
1.
Click the Device tree tab, and then double-click the Infranet Controller device for
2.
which you want to configure the number of concurrent sessions and concurrent users.
Click the Configuration tab. In the configuration tree, select the level at which you
3.
want to implement concurrent session restrictions. Then select:
Administrators > Admin Realms >Select Realm > Authentication Policies > Limits
to configure the number of concurrent sessions for admin realms.
Users > User Realms >Select Realm > Authentication Policies > Limits to configure
the number of concurrent sessions for user realms.
NOTE: The number of concurrent users can be configured only for user
realms.
Add or modify settings as specified in Table 17 on page 71.
4.
Click one:
5.
OK—Saves the changes.
Cancel—Cancels the modifications.
Table 17: Number of Concurrent Sessions and Concurrent Users for Infranet
Controller User Configuration Details
Option Function
Limit number of Limits the number of concurrent users
concurrent users on the realm.
Guaranteed Specifies the number of users
minimum between zero (0) and the maximum
number of concurrent users defined
for the realm, or you can set the
number to the maximum allowed by
your license if there is no realm
maximum.
Limit the Specifies whether the number of
number of concurrent sessions per user is
concurrent limited.
sessions per user
Chapter 7: Configuring Security Requirements for Administrators and Users
Your Action
Select this option to limit the number
of concurrent users.
Select or enter the number of users
between zero (0) and the maximum
number of concurrent users defined
for the realm.
Select this option to limit the number
of concurrent sessions per user.
71