CHAPTER 3
Adding Infranet Controllers
Importing an Infranet Controller Device Through Not Reachable Workflow
Copyright © 2010, Juniper Networks, Inc.
Importing an Infranet Controller Device Through Not Reachable Workflow on page 11
Requirements for Importing an Infranet Controller into NSM Through a Reachable
Workflow on page 15
Importing an Infranet Controller Through Reachable Workflow on page 15
Importing Multiple Infranet Controllers on page 16
Verifying Imported Device Configurations on page 19
You can add an Infranet Controller to your existing network using NSM and import its
configurations. Using the Add Device Wizard, you can configure a connection between
the management system and the physical device, and then import all device parameters,
policies, objects, VPNs, and so on.
Import an Infranet Controller through Not Reachable workflow into NSM by following
these procedures:
Installing and Configuring the Infranet Controller Device on page 12
1.
2.
Adding the Infranet Controller Device Through NSM on page 12
Configuring and Enabling the DMI Agent on the Infranet Controller Device on page 13
3.
Confirming Connectivity and Importing the Infranet Controller Device
4.
Configuration on page 14
11