Configuring Infranet Controller Host Checker Logs (Nsm Procedure) - Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING INFRANET CONTROLLER GUIDE REV 01 Manual

Configuring Infranet Controller Host Checker Logs (NSM Procedure)

Related
Documentation
Copyright © 2010, Juniper Networks, Inc.
The Infranet Controller writes a client-side log to endpoints, when client-side logging for
the Host Checker and Odyssey Access Client is enabled.
NOTE: Because these settings are global, the Infranet Controller writes a log
file to all clients that use the feature for which you enable client-side logging.
Also, the Infranet Controller does not remove client-side logs. Users need to
manually delete log files from their clients. For information about where the
Infranet Controller installs log files, see the Client-Side Changes Guide on the
Juniper Networks Customer Support Center.
To configure global client-side log settings:
In the NSM navigation tree, select Device Manager> Devices.
1.
Click the Device Tree tab, and then double-click the Infranet Controller for which you
2.
want to specify global client-side log settings.
Click the Configuration tab. In the configuration tree, select System > Log/Monitoring
3.
> Client Log > Settings.
Select the Host Checker check box.
4.
Click one:
5.
OK—Saves the changes.
Cancel—Cancels the modifications.
Configuring Infranet Controller Host Checker Access Restrictions (NSM Procedure) on
page 67
Creating Infranet Controller Global Host Checker Policies Overview on page 155
Chapter 15: Configuring Host Checker Policies
177