Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING INFRANET CONTROLLER GUIDE REV 01 Manual page 99

Copyright © 2010, Juniper Networks, Inc.
Chapter 8: Configuring the Infranet Controller RADIUS Server and Layer 2 Access
Click the Configuration tab. In the configuration tree, select UAC > Network Access
3.
> RADIUS Attributes > RADIUS Return Attributes Policies.
Add or modify RADIUS return attributes policies as specified in Table 23 on page 81.
4.
Click one:
5.
OK—Saves the changes.
Cancel—Cancels the modifications.
Table 23: RADIUS Return Attributes Policies Configuration Details
Option
Name
Description
Location Group
Enable Open port
Enable VLAN
VLAN
Enable Return Attribute
Function
Specifies a name for the
RADIUS return attribute policy.
Describes the RADIUS return
attribute policy.
Specifies the location groups
for the RADIUS attributes
policies.
Disables assigning endpoints
to a VLAN or returning any
RADIUS attributes.
Enables VLAN assignment
according to RFC 3580 by
returning the RADIUS tunnel
attributes to the network
access device.
Specifies the existing VLAN ID
on the network infrastructure
that you want to use for the
role(s) to which this policy
applies.
Enables the return-attribute
option.
Your Action
Enter a name for the RADIUS
return attribute policy.
Enter a brief description for the
RADIUS return attribute policy.
Select the location group from
the Non-member list and click
Add to move them to the
Members list.
NOTE: To apply the policy to
all location groups, do not add
any location groups and leave
the default setting (all) listed
in the Selected Location
Groups list.
Select this option to disable all
other RADIUS attributes
options.
Select this option to configure
VLAN assignment.
NOTE: Selecting this option is
equivalent to manually
specifying the three RFC 3580
RADIUS tunnel attributes in
the Enable Return Attribute
section.
Specify the existing VLAN ID.
Select this option to enable
return attributes.
81