Disabling The Dot1X Ports On An Enforcement Point Using The Uac Manager - Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING INFRANET CONTROLLER GUIDE REV 01 Manual

Related
Documentation

Disabling the Dot1x Ports on an Enforcement Point Using the UAC Manager

Related
Documentation
Copyright © 2010, Juniper Networks, Inc.
Specify the action to be taken in case of authentication failure:
6.
Deny access—Denies access to the client.
Move to VLan—Moves the client to VLANs available in the switch.
Select Run "Update Device" task to apply the device configuration.
7.
Select Run "Summarize Delta Config" task to view the difference in the configuration.
8.
Click OK to enable the dot1x ports on the enforcement points. The delta configuration
9.
that was pushed to the device is displayed.
Disabling the Dot1x Ports on an Enforcement Point Using the UAC Manager on page 185
Associating Enforcement Points with an Infranet Controller Using the UAC Manager
on page 182
Disassociating the Configuration Between an Enforcement Point and an Infranet
Controller on page 183
UAC Manager in NSM Overview on page 181
To disable dot1x ports on an enforcement point:
In the NSM navigation tree, select UAC Manager > Enforcement Point. The
1.
Enforcement Point workspace appears.
Select the Ex-series switch on which the dot1x port needs to be disabled.
2.
Select the Dot1x Enabled Ports tab. The dot1x enabled ports on the enforcement
3.
point is displayed.
Select the port on which dot1x needs to be disabled, and click the Delete Dot1x Port
4.
button. The Remove Dot1x on Selected ports dialog box appears with the list of ports
to be deleted.
Select Run "Update Device" task to push configuration changes on the enforcement
5.
point. The configuration status of the enforcement points changes to Managed, InSync.
Ports on which 802.1X is disabled are removed from the enforcement point.
Select the check box to run a Summarize Delta Config task that ensures the association
6.
between the enforcement point and the ports in the application database. The
configuration status of these devices become Managed, NSM Changed.
Click OK to disable the selected dot1x ports. The delta configuration that was pushed
7.
to the device is displayed.
Enabling Dot1x Ports on the Enforcement Points Using the UAC Manager on page 184
Associating Enforcement Points with an Infranet Controller Using the UAC Manager
on page 182
Chapter 16: Unified Access Control Manager
185