Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING INFRANET CONTROLLER GUIDE REV 01 Manual page 235

Copyright © 2010, Juniper Networks, Inc.
Click the Configuration tab. In the configuration tree, select System > Log/Monitoring
3.
> SNMP.
Add or modify settings as specified in Table 62 on page 217.
4.
Click one:
5.
OK—Saves the changes.
Cancel—Cancels the modifications.
Table 62: SNMP Agent Configuration Details
Option
Trap Settings
Check Frequency
Log Capacity
Users
Memory
Swap Memory
Disk
CPU
Send Traps for Critical Log
Events
Send Traps for Major Log
Events
SNMP Servers
Settings
SNMP Queries
Chapter 21: Configuring Logs in an Infranet Controller
Function
Specifies the check
frequency trap threshold .
Specifies the log capacity
trap threshold .
Specifies the users trap
threshold.
Specifies the memory trap
threshold.
Specifies the swap
memory trap threshold.
Specifies the disk trap
threshold.
Specifies the CPU trap
threshold.
Specifies that SNMP traps
will be sent for critical log
events.
Specifies that SNMP traps
will be sent for major log
events.
Specifies the servers to
which you want the
Infranet Controller to send
the traps that it generates.
Specifies the SNMP
queries for the Infranet
Controller.
Your Action
Enter the check frequency trap
threshold in seconds.
Enter a percentage for the log
capacity trap threshold.
Enter a percentage for the users trap
threshold.
Enter a percentage for the memory
trap threshold.
Enter a percentage for the swap
memory trap threshold.
Enter a percentage for the disk trap
threshold.
Enter a percentage for the CPU trap
threshold.
Select this option to send SNMP traps
for critical log events.
Select this option to send SNMP traps
for major log events.
Enter the hostname or IP address, port
number, and community.
Select this option.
217