Procedure); Configuring An Infranet Controller To Connect To A Junos Enforcer - Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING INFRANET CONTROLLER GUIDE REV 01 Manual

NSM Infranet Controller Configuration Guide
Related
Documentation
Configuring an Infranet Controller to Connect to a JUNOS Enforcer (NSM Procedure)
102
Enter an NACN password for this Infranet Enforcer in the NACN password box. You
7.
must enter this same NACN password when configuring the ScreenOS Enforcer.
Enter the administrator name and administrator password for signing into the
8.
ScreenOS Enforcer.
Enter the serial number(s) of the ScreenOS Enforcer. You can view the serial number
9.
on the home page of the Infranet Enforcer WebUI, or by entering the following Juniper
Networks ScreenOS CLI command:
get system
To configure ISG-IDP, select Use IDP Module. For more information on configuring
10.
ISG-IDP on a enforcer, refer to "Configuring ISG-IDP as a Sensor on the Infranet
Controller (NSM Procedure)" on page 193.
NOTE: For the Infranet Controller to interoperate with IDP, the
ic-xxxx-ADD-tctrl coordinated threat control license is required.
Select No 802.1X from the Location Group list if you are not using an Infranet Enforcer
11.
as an 802.1X RADIUS client of the Infranet Controller.
Click one:
12.
OK—Saves the changes.
Cancel—Cancels the modifications.
Configuring an Infranet Enforcer as a RADIUS Client of the Infranet Controller (NSM
Procedure) on page 84
Configuring an Infranet Controller to Connect to a JUNOS Enforcer (NSM Procedure)
on page 102
Configuring Infranet Controller Source IP Access Restrictions (NSM Procedure) on
page 61
Configuring Infranet Controller Host Enforcer Policies (NSM Procedure) on page 105
You can use a JUNOS Enforcer with the UAC solution. A JUNOS Enforcer is a J Series
Services Router or an SRX Series Services Gateway configured as a Layer 3 enforcement
point. See the Unified Access Control Supported Platforms document for compatibility.
The JUNOS Enforcer connects with the Infranet Enforcer over an SSL connection. To
initiate the connection between the two appliances, you must specify the password and
serial number of the JUNOS Enforcer.
Copyright © 2010, Juniper Networks, Inc.