Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING INFRANET CONTROLLER GUIDE REV 01 Manual page 153

Copyright © 2010, Juniper Networks, Inc.
Table 44: RADIUS Server Configuration Details
Option
Auth Server Name
Auth Server Type
Radius Settings > Primary Server tab
Radius Server
NAS-Identifier
Authentication Port
Shared Secret
Accounting Port
NAS-IP-Address
Timeout (minutes)
Retries
Users authenticate using
tokens or one-time
passwords
Chapter 13: Configuring Authentication Servers
Function
Specifies a name for the
auth server.
Specifies the auth server
type.
Specifies a unique name or
IP address for the RAIDUS
server.
Specifies a name for the
network access server
(NAS) client, which
communicates with the
RADIUS server.
Specifies the
authentication port value
for the RADIUS server.
Specifies the shared
secret.
Specifies the accounting
port value for the RADIUS
server.
Specifies the NAS IP
address value passed to
RADIUS requests.
Specifies the time interval
for the Infranet Controller
to wait for a response from
the RADIUS server before
timing out the connection.
Specifies the number of
retries an Infranet
Controller can make after
the first connection
attempt fails.
Specifies that the
password entered by the
user cannot be submitted
to other SSO enabled
applications.
Your Action
Enter a name for the auth server.
Select Radius Server.
Enter the name or IP address.
Enter the name for the NAS client.
Enter the port value.
NOTE: Typically this port is 1812, but
some legacy servers might use 1645.
Enter the shared secret.
Enter the port value.
NOTE: Typically this port is 1813, but
some legacy servers might use 1646.
Enter the NAS IP address.
Enter the timeout interval in minutes.
Enter the number of retries.
Select the Users authenticate using
tokens or one-time passwords check
box.
135