Using Templates; Chapter 5 Using Templates; Creating And Applying An Infranet Controller Template; Creating The Template - Juniper NETWORK AND SECURITY MANAGER 2010.4 - CONFIGURING INFRANET CONTROLLER GUIDE REV 01 Manual

CHAPTER 5

Using Templates

Creating and Applying an Infranet Controller Template

Creating the Template

Copyright © 2010, Juniper Networks, Inc.
Creating and Applying an Infranet Controller Template on page 29
Promoting an Infranet Controller Configuration to a Template on page 31
Reverting an Infranet Controller Configuration to Default Values of a
Template on page 31
You can create and apply configuration templates for setting up new Infranet Controller
devices through NSM.
Create and apply templates by following these procedures:
Creating the Template on page 29
1.
2. Applying the Template on page 30
To create an Infranet Controller template:
From the left pane of the NSM UI, click Configure.
1.
Expand Device Manager and select Device Templates. The Device Templates
2.
workspace appears on the right side of the screen.
Click the Device Template Tree tab, click the New button, and select IC Template.
3.
The New Device Template dialog box appears.
Name the Infranet Controller template, and select a color for the template.
4.
Enter the following basic information:
5.
Device description
IP address
Admin user name
Admin user password
Click OK to save the template. The newly created templates will appear under the
6.
Device Template Tree.
29