Checking The Analog Output Unit (Mirror Mode) - Yamaha CS1D Operating Manual

CS1D Operating Manual (Start-up)

Checking the analog output unit (Mirror mode)

In Mirror mode if the AO8 is correctly connected to the engine, the OUTPUT UNIT ID indicator of the AO8 will show
the ID number of that unit (i.e., the number of the OUTPUT connector on the engine to which the AO8 is connected),
and the dot ( . ) will light on both sides of the ID number.
If the connections of the AO8, the setting of the
INPUT SELECTOR switch, or the word clock syn-
chronization are not correct, one of the following
error displays will appear in the OUTPUT UNIT ID
indicator.
E2 ........................The AO8 is connected to an
INPUT connector of the engine.
Re-connect it to an OUTPUT
connector.
E3 ........................The cable connected to the
INPUT connector on the rear
panel of the AO8 has been dis-
connected, or is connected to the
wrong destination. Check the
cable.
UL (unlocked) ....The word clock is not synchro-
nized.
Check the connections of the
AO8's WORD CLOCK IN con-
nector, or the word clock settings
of the CS1D ( p.28).
UC (unconnected) ..Control signals are not being
received correctly.
Make sure that the engine is
powered-on.
ID number and A (or b) displayed alternately
Since control signals from the CS1D forcibly
switched the valid engine to A (or B), the setting of
the INPUT SELECTOR switch of the AI8 does not
match the actual operation.
This display does not signify an actual error. How-
ever as necessary, check the setting of the INPUT
SELECTOR switch or the setting of the CS1D.
20
ID number of the AO8
(when the AO8 is connected to the OUTPUT 2
connector of the engine)
1 2 3 4 5 6
OUTPUT UNIT ID
7 8
OUTPUT UNIT NO.
INPUT SELECTOR
A
B
POWER
ON/ OFF
ANALOG OUTPUT BOX