Changing The Channel Assignments - Yamaha CS1D Operating Manual

Changing the channel assignments

When the PM1D system is in its default state, INPUT blocks 1–4 are assigned input channels 1–12, 13–24, 25–36, and
37–48 respectively. Similarly, ST IN channels 1–4 are assigned to the ST IN block.
However, you can change these assignments by using the SELECTED INPUT CHANNEL block MODULE [FLIP] switch
and the MASTER block GLOBAL LAYER [1-48]/[49-96] switches, as described below. {On the 48 channel model, the
GLOBAL LAYER [49-96] switch cannot be selected. Only the GLOBAL LAYER [1-48] switch is valid.}
Using the MODULE [FLIP] switch to change the
channel assignments
INPUT block 2
CH 13-24
FLIP
CH 1-12
INPUT
block 1
CH 1-12
FLIP
CH 13-24
INPUT block 4
34 CH 37-48
12 CH 25-36
ST IN block INPUT
block 3
12 CH 25-36
CH 37-48
34
Chapter 4. Basic operation for input channels
Using the GLOBAL LAYER [1-48]/[49-96] switches
to change the channel assignments (96 channel
model only)
INPUT block 2
CH 13-24
CH 1-12
INPUT
block 1
GLOBAL LAYER
CH 61-72
CH 49-60
GLOBAL LAYER
If operating the INPUT block/ST IN block does not
produce the expected result, make sure that the
above switches are set appropriately.
INPUT block 4
34
CH 37-48
12 CH 25-36
ST IN block INPUT
block 3
78 CH 85-96
56 CH 73-84
33