Yamaha CS1D Operating Manual page 190

CS1D Operating Manual (Basic Operation)
3. Use the [INPUT AFL] switch located in the CUE
section of the MASTER block to specify the posi-
tion from which the signal will be sent to the CUE
bus when the [CUE] switch of an input channel is
pressed.
When the [INPUT AFL] switch is off, the post-fader
signal will be sent to the CUE bus. When this switch
is on, the pre-fader signal will be sent.
4. Use the [OUTPUT PFL] switch of the CUE section
to specify the position from which the signal will be
sent to the CUE bus when the [CUE] switch of an
output channel is pressed.
When the [OUTPUT PFL] switch is off, the pre-
fader signal will be sent to the CUE bus. When this
switch is on, the post-fader signal will be sent.
5. Use the [DCA PRE PAN] switch of the CUE section
to specify the position from which the signal will be
sent to the CUE bus when the [CUE] switch of a
DCA group is pressed.
When the [DCA PRE PAN] switch is off, the post-
pan signal will be sent to the CUE bus. When the
switch is on, the pre-pan signal will be sent.
Hint
The setting of this switch only affects DCA groups to
which input channels are assigned. For DCA groups
to which output channels are assigned, the signal will
always be sent to the CUE bus from a location imme-
diately after the [ON] switch.
6. Use the [LAST CUE] switch of the CUE section to
select either LAST CUE mode ([LAST CUE] switch
on) or MIX CUE mode ([LAST CUE] switch off) as
the mode of operation when two or more [CUE]
switches within the same group are pressed.
The operation of the two modes differs as follows.
LAST CUE mode ([LAST CUE] switch is on)
Only the channel/DCA group whose [CUE] switch
was pressed last will be monitored.
Hint
In LAST CUE mode, pressing the [CUE] switch of a
channel will also cause the [SEL] switch to operate in
tandem, selecting that channel.
MIX CUE mode ([LAST CUE] switch is off)
All channels/DCA groups within the same cue
group whose [CUE] switches are on will be moni-
tored.
Hint
It is not possible to simultaneously turn on [CUE]
switches that belong to different groups. The group
to which the last-pressed [CUE] switch belongs will
take priority, and the signals of that group can be
monitored.
In this case of channels that are paired, both channels
will be turned on.
118
7. Make sure that the [SOLO] switch of the CUE sec-
tion is off (Cue mode).
8. Turn on the [CUE] switch of the desired channel/
DCA group.
The cue signal of the corresponding channel will be
output from MONITOR OUT jacks A, the PHONES
MONITOR A jack, and the CUE OUT jacks.
9. To defeat cue, press the currently-on [CUE]
switch(es) once again.
Hint
When you press the [LAST CUE] switch to change
from LAST CUE mode to MIX CUE mode (or vice
versa), the previously-valid cue (solo) will be can-
celled.