Talkback Section - Yamaha CS1D Operating Manual

CS1D Reference Manual (Hardware)

TALKBACK section

This section sends the talkback signal to the desired bus, the MONITOR B jacks, and the desired output jacks.
1 TALKBACK 1 jack
This is an XLR-3-31 jack for connecting a talkback
mic.
Hint
The TALKBACK 2 jack on the rear panel of the CS1D
provides another talkback mic input in addition to
the TALKBACK 1 jack. The talkback signal that is
input from these two jacks is mixed within the CS1D,
and sent to the same bus or output jacks.
2 TALKBACK [LEVEL] volumes
These are analog volume controls for the input levels
of talkback 1/2.
Hint
The value of these levels cannot be stored in a scene
memory or controlled from outside (or from the
internal software).
3 TALKBACK [+48V] LEDs
These LEDs indicate the on/off status of phantom
power for the TALKBACK 1/TALKBACK 2 jacks.
(The LED will light when phantom power is on.)
Phantom power can be switched on/off in the display
(MON/CUE function TALKBACK screen).
78
1
2
5
7
4 TALKBACK [+10 dB] LEDs
5 TALKBACK ASSIGN [TO MON B] switch and LED
6 TALKBACK ASSIGN [TB OUT] switch and LED
3
4
3
4
6
These LEDs indicate the input sensitivity of the
TALKBACK 1 jack and the TALKBACK 2 jack.
When the input sensitivity is +10 dB, the LED will
light and a +10 dB input signal will be nominal
input. When off, the LED will be dark and the input
sensitivity will be –44 dB.
The input sensitivity can be switched in the display
(MON/CUE function TALKBACK screen).
This switch sends the talkback signal to MONITOR
OUT jacks B.
When this is on, the switch LED will light.
The talkback signal cannot be sent to MONITOR
OUT jacks A. If necessary, use the IN PATCH func-
tion to patch the talkback signal to an input chan-
nel and sent it to MONITOR OUT jacks A.
This is an on/off switch for the signal that is sent
from the talkback direct output. (When on, the
switch LED will light.)
The physical output jacks used as the talkback direct
output can be selected in the display (MON/CUE
function TALKBACK screen).