Yamaha CS1D Operating Manual page 596

Is the GATE/COMP set to an extreme threshold or
ratio? ("CS1D Reference Manual (Hardware)"
p.25, 27)
Is the EQ attenuator raised?
("CS1D Reference Manual (Hardware)"
Is the output channel [LEVEL] encoder raised?
("CS1D Reference Manual (Hardware)"
Check the levels in the METER screen.
("CS1D Reference Manual (Software)"
Is the [GAIN] switch (maximum output setting) of
the analog output card set to the correct position?
refer to the manual included with the I/O cards.
Has the DCA fader to which that channel is assigned
been raised? ("CS1D Operation Manual (Basic Oper-
ation)" p.93)
Sound is distorted
Is the word clock set correctly?
("CS1D Operation Manual (Start-up)"
"CS1D Reference Manual (Software)"
Are the head amp and [GAIN] encoder set correctly?
("CS1D Reference Manual (Hardware)"
Is the input channel fader raised excessively? ("CS1D
Reference Manual (Hardware)"
Is the STEREO A/B channel fader raised excessively?
("CS1D Reference Manual (Hardware)"
Is the EQ gain raised excessively? ("CS1D Reference
Manual (Hardware)" p.29)
Is the analog output card [GAIN] switch (maximum
output setting) set to the correct position?
the manual included woth the I/O cards.
Sound is output even though not patched to
an output channel
Is the signal set to DIRECT OUT? ("CS1D Operation
Manual (Basic Operation)"
Is the signal set to INSERT OUT? ("CS1D Operation
Manual (Basic Operation)"
No response when the MIX SEND encoder is
rotated
Is the MIX bus set to FIX MODE?
("CS1D Reference Manual (Software)"
Is MIX SEND turned on? ("CS1D Reference Manual
(Hardware)" p.23)
In the case of the send point is set to POST, has the
fader been lowered? ("CS1D Reference Manual
(Hardware)" p.23, "CS1D Reference Manual (Soft-
ware)" p.158)
A paired channel does not sound like stereo
Is the pan mode setting and the pan value correct?
("CS1D Reference Manual (Hardware)"
"CS1D Reference Manual (Software)"
p.29)
p.63)
p.58)
p.24, 28,
p.53)
p.21, 31)
p.32)
p.53)
refer to
p.91)
p.85)
p.155)
p.30,
p.158)
The volume of a specific channel rises and
falls
Is ducking specified for GATE/COMP? ("CS1D
Operation Manual (Basic Operation)"
Cannot save a scene memory or library data
Are you attempting to save over read-only memory
number or number that has been memory protected?
("CS1D Reference Manual (Software)"
In TC EVENT, the EVENT RECALLING parameter
may have been set to ENABLE. ("CS1D Reference
Manual (Software)" p.33)
Can't save to memory card
Is the memory card protected?
Does the memory card contain sufficient space for
saving the data?
Can't load from memory card
TC EVENT IN may have been set to ENABLE.
Cannot transmit/receive MIDI data
Does the MIDI PORT selection match the connec-
tions?
("CS1D Reference Manual (Software)"
Are the MIDI MODE and channel settings made cor-
rectly for the transmitting and receiving devices?
("CS1D Reference Manual (Software)"
Has an event been specified for the program change?
("CS1D Reference Manual (Software)"
Operating the faders does not produce the
desired level adjustment
Are the [LAYER] or [FLIP] switches set to the appro-
priate fader mode or mixing layer? ("CS1D Reference
Manual (Hardware)" p.5, 13)
Only a specific channel is heard from the
MONITOR or PHONES jack
Is CUE turned ON? ("CS1D Operation Manual
(Basic Operation)" p.116)
Noise is heard on a connected external
device (recorder, etc.)
Is the word clock setting correct? ("CS1D Operation
Manual (Start-up)" p.24, 28, "CS1D Reference
Manual (Software)" p.53)
Is an unsynchronized signal being input? ("CS1D
Reference Manual (Software)"
Is the Dither setting appropriate? ("CS1D Reference
Manual (Software)" p.56)
Is the OSCILLATOR, TALKBACK, or SUB IN oper-
ating? ("CS1D Operation Manual (Basic Opera-
tion)" p.120)
Troubleshooting
p.55)
p.18, 166)
p.29)
p.29)
p.29)
p.55)
51